2/14/2023 0 Comments Arduino rtty![]() Single USB Port for CAT, Audio and Firmware Uploadįlexible Installation, Panel Mount or via Cable connection The Tx and Rx audio could be controlled by PC or the 2 potential meters.įully Isolated, even with USB Connections You could even use the module's USB port for firmware uploading with Xloader. The uBitx radio's PTT is controlled by PC via radio CAT protocol, and the protocol used for radio communication is Yaeasu FT-817. The key step of the installation is to solder the RX, TX audio and 5V power supply to the digi-interface board. The digi-interface module is easy to install, you could either install it on top of uBitx main board or mount it on the rear panel of your uBitx radio. ![]() With this add-on board, the uBitx is able to work on ham radio digital modes, FT8, JT65, PSK or RTTY etc. It features with full isolation, single usb for CAT and Audio control, and Rx and Tx audio level controllable. The uBitx digi-interface module is an add-on module board for uBitx transceiver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |